- M Series oven control panel is blank or dim but unit still works
- Pressing oven control panel works, but nothing is displayed
- The oven can be turned on, but oven temperature, mode, or time not displayed on panel
- Display is hard to read, blinking, dim, faded, or appears different than normal
- Words or numbers on display not fully illuminated, or partial words and numbers displayed
Steps to Verify Issue:
If the control panel is blank, or hard to read (dim), but the unit is working properly:
- Verify the unit is not in Sabbath mode. Refer to the product use and care guide for further information.
- This also applies if display is blinking.
- Wolf Sabbath Mode and Star-K Information.
- Turn off the unit power at the power supply source and wait 30 seconds.
- Turn on the unit power and check the display again.
- Ensure there are no brownouts or power outages in the area; if so, wait until full power is restored and try the oven again.
- Refer to M Series No Display for more information.
The control panel does not have individual light bulbs that can be changed. If the display is not working or partially working after following the steps above, service is needed.
DID THIS ANSWER YOUR QUESTION?
Thank you for your request. A Customer Care representative will contact you.
An error occurred. We were unable to submit your request.
We're standing by with answers
Whether you're shopping for appliances or have questions about those you already own, we've got the resources you need. Talk directly to a customer care expert at the Sub-Zero, Wolf, and Cove service center, or connect with an appliance consultant at an official showroom near you. Get quick answers online, or reach a certified service provider or installer. And much more.
Call us at (800) 222-7820