Priming the Water Dispenser Tank

To prime the water tank on initial use or after a water filter is replaced:

Built-In Models with External Dispenser

1. Place a water glass under the dispenser.
2. Press and hold the Water button for no more than 60 seconds.
   • Some air may dispense before water begins to flow. This is normal.
   • The dispenser locks out if the button is held for more than 60 seconds.
3. If there still is no water, wait 10 seconds, then press the Water button again.
   • Once the water tank is full, the unit begins dispensing.

Built-In Models with Internal Dispenser and All Designer (Formerly Integrated) Models

1. Press a water glass against the dispenser until water begins to flow.
   • The dispenser locks out if the dispenser is held for more than 60 seconds.
2. If water does not dispense within 60 seconds, remove the glass, wait 10 seconds, then reapply the glass to the dispenser until water begins to flow.
   • Once the water tank is full, discard the first few glasses of water.

Refer to the product Use and Care Guide for further information.

If these troubleshooting steps do not resolve the issue, service is necessary to expertly diagnose and repair the product. Contact Factory Certified Service to schedule an appointment for repair.