Skip to main content

Designer Series Thermistor Faults | Open | Error 10 0 00

Topics:

  • What is error code 10 0 00 on a Designer (formerly Integrated) model?
  • Designer shows 10 0 00
  • Designer Drawers error code 10 0 00
  • 10 0 00
  • 10000

Cause:

  • Control board has been replaced but has not been programmed
  • Open thermistor on unit where the model is programmed for DEFL configuration

Troubleshooting:

  1. Turn the home circuit breaker to the unit off for 30 seconds then back on again.
  2. Retest the unit operation. If the unit operates without any further errors, no action is required.
  3. If these troubleshooting steps do not resolve the issue, service is necessary to expertly diagnose and repair the product. Contact Factory Certified Service to schedule an appointment for repair.

DID THIS ANSWER YOUR QUESTION?

Need further assistance? Contact Customer Care at 800.222.7820 or provide your information below and request a Customer Care representative contact you.

Related Questions 

We're standing by with answers

Whether you're shopping for appliances or have questions about those you already own, we've got the resources you need. Talk directly to a customer care expert at the Sub-Zero, Wolf, and Cove service center, or connect with an appliance consultant at an official showroom near you. Get quick answers online, or reach a certified service provider or installer. And much more.

 

Call us at (800) 222-7820