Skip to main content

Vacuum Seal Drawer Installation Requirements

Topics:

  • Vacuum Seal Drawer installation requirements

Answer:

The Vacuum Seal Drawer can be installed in a standard or flush inset application.

  • Finish the edges of the opening. They may be visible when the drawer is open.
  • For standard installations, the face trim overlaps stiles and rails. Refer to the chart below.
  • For flush inset installations, a minimum 1/8" (3) reveal is required on all sides. Each corner of the opening must be exactly 90° for consistent reveals.
  • An anti-tip block must be installed to prevent the Vacuum Seal Drawer from tipping forward when opened.
Installation Requirements
Base SupportMin
Vacuum Seal Drawer75 lb (34 kg)
Trim Overlap
Top0" (0)
Bottom0" (0)
Sides11/16" (18)

Refer to the product Installation Guide for further installation information.

DID THIS ANSWER YOUR QUESTION?

Need further assistance? Contact Customer Care at 800.222.7820 or provide your information below and request a Customer Care representative contact you.

Related Questions 

We're standing by with answers

Whether you're shopping for appliances or have questions about those you already own, we've got the resources you need. Talk directly to a customer care expert at the Sub-Zero, Wolf, and Cove service center, or connect with an appliance consultant at an official showroom near you. Get quick answers online, or reach a certified service provider or installer. And much more.

 

Call us at (800) 222-7820