Skip to main content

Legacy Dual Fuel Range Knob Displays HOT

Topics:

  • Legacy Dual Fuel Range turned on by itself when it was not in use
  • Legacy Dual Fuel door locked, HOT is shown
  • HOT appears on Legacy Dual Fuel oven knob with a long beep
  • Self-clean stops and "hot" is shown

Cause:

  • Unit power failure
  • Oven temperature too hot for cooking mode selected
  • Loose or defective connection at J2 connector on oven controller
  • RTD out of specifications
  • Mode attempted while temperature above threshold

Troubleshooting:

  1. Turn the oven selector bezel to cooking mode, then back to Off to reset.
  2. Open the oven door to cool the oven cavity temperature.
  3. Turn the home circuit breaker to the unit off for 10 seconds then back on again.
  4. Retest the unit operation.
  5. Allow the oven to cool down for up to 8 hours, then select mode and temperature desired.
  6. If these steps do not resolve the issue, no further troubleshooting advice is available. Contact Factory Certified Service to schedule an appointment for repair.

See also, Wolf Oven Door Will Not Unlock.

DID THIS ANSWER YOUR QUESTION?

We're standing by with answers

Whether you're shopping for appliances or have questions about those you already own, we've got the resources you need. Talk directly to a customer care expert at the Sub-Zero, Wolf, and Cove service center, or connect with an appliance consultant at an official showroom near you. Get quick answers online, or reach a certified service provider or installer. And much more.

 

Call us at (800) 222-7820