Topics:

• Wolf Dual Fuel units in Showroom Mode
• Is there a kit part number that is necessary to purchase in order to put the Induction Range in to Showroom Mode?
• Should a Factory Certified Service Company be involved when putting the DF or IR units in Showroom Mode?
• Showroom instruction sheet, part number 828553
• Showroom Mode kit, part # 828197

Answer:

Install the Wolf Dual Fuel Range and Induction Range units in to a showroom on a 115 VAC designated circuit.

1. On the control panel, touch Settings.
   
   
2. Touch Showroom Mode. Scroll left or right to highlight the On or Off option.
   
3. Touch the selection. The Set Showroom screen appears.
   
4. Touch Set. The Home screen appears. When the unit is in Showroom Mode, "Showroom" appears on the Home screen.

Refer to the Sub-Zero, Wolf, and Cove Showroom Mode Guide for more information and instructions.

• Showroom Mode is intended for units on display at a dealer or showroom.
  • The showroom kit part number is 828197; instruction sheet part number is 828553.
  • Electronic controls and surface burner ignitors will be active to mimic customer operation, while oven heating elements will be disabled.
    • The call for heat (CFH) light on the Dual Fuel Range will not illuminate as there is no longer a CFH LED.
    • An active call for heat status will appear on the electronic control head (ECH), which will be simulated in Showroom Mode. 
• To disable Showroom Mode, reverse the procedure, and install the unit with a 240 Volt electrical supply.
  • If the Showroom Mode kit is not properly uninstalled, customer may experience light and fan operation but no heat.